Analogue meets digital: the instrument cluster of the new
In the middle and in direct view of the driver is the analogue rev counter, its needle integral to its truly classic design. To the left and right, two high-resolution displays provide you with a variety of information as and when you need it, such as the navigation map or Night Vision Assist.
On the left-hand side of the rev counter is the speedometer. In its centre, you can see data relating to adaptive cruise control, for example. In the display field on the outside left, the outside temperature is shown.
On the right-hand side, the possibilities are even more varied. The inside display field is occupied by information from the on-board computer, the fuel gauge or range remaining. In the field on the outside right, you can see the time. And there's also the option of viewing the map of the navigation system.
* The published consumption (l/100km and Wh/km), emissions (g/km) and kilometre (km) range figures (excluding any
The specified charging outputs and times (hour/minutes) are dependent on various factors: in general, the charging output and time can vary due to physical and chemical limits, depending on factors such as the available output of the country-specific energy infrastructure, the customer's own domestic installation, the temperature, interior pre-conditioning and charging status, as well as the age of the battery. Charging times may therefore be significantly higher than those specified. To achieve the optimum value of the specified DC charging time (DC = direct current) for a charge status increase from 5 to 80%, a CCS (combined charging system) fast-charging pedestal with > 270kW and > 850V is required, as well as a battery temperature of 30°–35°C. The charging status when commencing charging must not exceed 5%. For physical and chemical reasons, the charging speed decreases as the battery approaches its full capacity. Therefore, it usually makes sense to use fast DC charging to charge the battery up to 80% or up to the required range. The predominant use of CCS fast charging pedestals leads to a long-term increase in charging times. For regular fast DC charging, we recommend a maximum charging output of 50kW. When charging in a domestic environment, AC charging (AC = alternating current) is recommended. Using an (AC) industrial electrical outlet will result in improved efficiency and a much shorter charging time compared to using a household socket.
Published figures should only be used for the purpose of comparison between vehicles. Please contact an Official